Thanks m8!
1 Like
So much awesome mate. Cheers!
1 Like
Now my goal is to get the board splashproof. I covered up the motor connections with self welding rubber tape. And also took care of the davega x with some ninjaflex. The enclosure lid should be splashproof but the loopkey port isnt so I wanted to make a cover for the whole electronics box. Had some duct tape laying around so why not… Its foldable and can be assembled with velcro. Fits right into my small backpack. Might look a bit goofy but it works!
7 Likes
The davega is quite useful to see the lifespan of parts! I didnt configure all the parts but the drive I got was used since I got the belts.
Before I got the DavegaX I rode the board for 200 km and I got the drive second hand. I estimate there is at least 1500 km on this trampa belt drive (excluding belts), and its still holding up great! 
Just opened the drive after not taking it apart for almost 500 km and it looks pretty clean…
These drives are tanks! Also mostly because I use an inner bike tire to enclose the drive. Only things that are a little worn out are the idler pulleys/bearings and one of the idler brackets. @Trampa do you still have parts of the old belt drive?
5 Likes
The Bearing is a skate bearing, 608. The Bracket is not in stock any longer.
3 Likes
Thanks Frank!
Why are these helmets so hard to find?
No idea… I found you can only find them for a reasonable price on amazon
TSG helmets are nice but their customer service sucks.
Here is my experience with them
4 Likes
Last picture with the belt drives… for now…
Removed them to send the hanger to Etoxx 
Cant wait to get the new babies
5 Likes
Current setup video 
please let me know what you guys think, still figuring out this stuff 
4 Likes
hey dude
hanger is machined!
will be shipped tomorow
6 Likes
Awesome, thanks! 
Would you be willing to share the stl of the gear drive guards you you printed?
1 Like
Do you have it installed already?
1 Like