Flipsky vx1 wont control my motors

Help, im building my first esk8, everything is working when im calibrating and testing through the vesc tool program. But when i connect my vx1 remote i cant control the motors, i push forward and nothing happens. Please help.

u tested using the keyboard arrow keys? did u set the control mode back to uart / ppm?

u r using the vx1 as uart or ppm remote? if ppm, did u do the ppm remote setup?

also, wrong thread, try this one:

1 Like

Just to clarify, you did use the input wizard, yes?

Change control mode to current hyst reverse instead of off.

yes i did

i set up the vx1 using the input wizard and selecting the top one ppm like a guy in a video i watched said, wnt through everything and the controller connects to the receiver but wont control anything

Screenshots of settings plz

1 Like


show us how u wire the remote receiver

1 Like

https://imgur.com/gallery/5HLVYci
should be wired correctly

please change ur control mode to uart only mode or uart + ppm, because u wired it as uart device

2 Likes

how do i do that, i saw a guy on youtube do it exactly like me and it worked. but ill try

1 Like

well shit, its still not working

did u do it for both side just to be sure? and did u powercycle it at least once?

1 Like

yes dith that, doesnt work

try the other port?

1 Like

no luck

im calling in support

@YUTW123 and @ShutterShock :joy:

2 Likes

Tried swapping Tx and RX?

2 Likes