Flipsky 75100 foc for esk8, good ?

[jaykup]

@barthchris

I have several Nrf52840 modules. Do they need to have firmware flashed onto them or will generic nrf52 modules work if Gnd, 5V, RX, TX is connected?

Generics need to be flashed, but will work. That’s what I used to configure it. This is probably obvious, but RX on the NRF module goes to the TX on the VESC

See here how to do that, I did the ST-Link method. (same process for the 52):

NRF51822 Flashing / Setup in Windows using a STLink V2

NOTE: You can use your VESC to do this whole think a lot easier. See video below: https://www.youtube.com/watch?v=PFFiVxFHDM4 How to do it the hard way: After some issues getting mine setup and working I thought I’d post a guide of how I did it. Please do double check pins with what your board/programmer lists as they could vary Also there is a guide here if you want to follow Vedders guide:

Vedders Guide:

<a href="https://github.com/vedderb/nrf51_vesc/blob/master/README.md" re…