Flipsky 6.6 dual plus with VX2 pro remote and flipsky BT module

DIY Builds
1

Hi guys, so far I have everything working pretty well. Only problem now is that the mobile vesc tool won’t stay connected to my slave side, the tool finds my BT when I scan, then I click connect and it stays for a minute then says the firmware is wrong and to make sure the port belongs to the vesc.

When I unplug my VX2 remote from the master side, and plug in the BT to that connection, the vesc tool finds it and stays connected. Does anyone know how to get the VX2 remote and the BT to work at the same time? Or do I just have to unplug my remote when I want to connect with the vesc tool?

1 Like
2

I would do a re install of the vesc firmware and start over.
Do upload.to all.

1 Like
3

Have you managed to get it working? I’m planning on doing something similar, but I figured that would be a problem. Apparently both the Bluetooth module and the remote send CAN forward commands, potentially at the exact same time which causes problems.