Definitely agree here. Its always a royal pain in the ass trying to solder on my last male XT90 when I dont have a female lying around to plug it into.
That said, I’m still no where near being able to figure out how much these will cost. Its really going to depend on how much time it takes me to assemble each one. If I cant get the price on these down to single digits per pair, then I really doubt a bag of 5 or 7 pairs is going to sell very well if it is more than $50. I would love to get there, but we will see.
I have a resin printer that the Robot very generously foisted upon me. I have yet to actually make it work though. Thoon.
That $200 a liter is pretty cost prohibitive.
I switched to a 0.25mm nozzle on my prusa and I am able to get much better resolution on these now (at the cost of print time). Because of that I redesigned them again trying to see how small I can get the connector while still keeping enough distance between the pins.
This is the result: