I can do that too but my key is going to sit even deeper than that since I’ve have minimal ground clearance
2nd option would be to mount at the baseplate.
I can do that too but my key is going to sit even deeper than that since I’ve have minimal ground clearance
2nd option would be to mount at the baseplate.
Yeah I’m running on thane, not sure bout you. But it’s not horrible but not “ideal”
I’ll show you a picture in a bit with what I’m dealing with
Baseplate mounting might be worth it tbh
Just have to block the hole I already created for the loop key
Yeah shoot me a pic!
thanks for bringing this back up, I was just noodling over where to put a loop key on a hummie. @deucesdown wins for… ah… function over form, lol, I might have to do this
I was too lazy to make my loopkey longer so I said screw it
It could be made pretty! I just give no fucks. The big ziptie is for EPO (emergency power off).
Here’s another
Haha the hex head bolts. If I could find cheap long bolts I’d switch to them for cutaway decks. Holding a phillips tha’s designed to cam out while turning the locknut is not fun.
Here’s another
At least you’re true to your word, haha.
Haha I didn’t think it was this low
I’ll have to move the charge port and loopkey to the baseplate for sure and probably topmount
This build is pushing it with clearances
Ahhh yes. Almost the same board. Nice to know
Top mount? How’s your board running
Not yet. Waiting for parts. Antispark
Then assemble and do balance leads. Mock up.
It’s slow…
Top mount allows space for the cables in the cutout. Also charge cables there
Oh your like pushinnnnngggg it with clearance
Yup
Full lean 10mm hex key
Will have to change a couple things but I have most the things here to give me a little more clearance
My lord what wheels are you running on
Venom Magnums
78x70mm
74a
Awww makes sense
Yup. Almost double my clearance just by going top mount