Just wanted to share with you how to mod benchwheel remote with wireless charging
First goes disassembly
Next think is fitting Wireless Charging Receiver
In this step I needed to cut off one screw point and trim 3 of them
Fitting after adjustments
Now some fishpaper to insulate coil and remote pcb
All thats left is to screw in remote pcb
And solder wires to charging port
Wireless charging test
All looks good, after testing I used some hot glue to hold solder points in place just forgot to take pictures.
Assembled remote test
Wired charging still works.
Next thing to do would be to open my 10S charger and integrate it with disassembled phone charger and wireless charger
so I can place my remote on it whenever Im planning to charge my board. I just need to find fitting box for it, because there is not that much room.
Here again you can find wireless receiver module I have used. It should work with any remote as long as you are using overcharge protect in it and have enough place.
Hope you all like it, cheers