Archived: the OG noob question thread! 😀

[Andy87]

2 single esc connection

You wire them up in parallel. So your battery plus goes to esc1 plus and esc2 plus at the same time. Same for minus. For switching on off you will have an antispark Loopkey in the line or any other anti spark switch. The escs use CAN to communicate with each other. That’s just two wires, can high to can high and can low to can low from one esc to the other. If you want to run split ppm than you don’t need that CAN cable, but 2 receiver. One for each esc. Both receiver are paired to one remot…