You can do it on tinkercad pretty easily
Just delete all the parts you don’t want by dropping a negative box on them
3 Likes
Hi guys!
Does someone have the Torque board direct drive abec adapter CAD?
I’m on SolidWorks, So, a step, a parasolid could be great!
Thanks!
2 Likes
From net picture and my Kegel flange, I draw this.
I will probably 3D print it on a MArkforged next week, but if someoneelse wanna try…
Uploading: 2022-08-26_10h17_51.png…
TBDD-ABEC.STEP (1.1 MB)
5 Likes
Anyone have a drawing of the hole pattern of a stormcore 60D+ (id assume 60d is the same) including both the threaded bottom holes and the through holes on the sides?
2 Likes
thanks! it’s good to know that thread exists.
2 Likes
Its one of my favourites 
2 Likes
TBDD ABEC Flange.
Tested and working fine. Printed with a Markforged and ONYX.
TBDD-ABEC_R4.STL (1.6 MB)
TBDD-ABEC_R4.x_t (539.2 KB)
4 Likes
How many miles and how hard have you been pushing it? Those tabs don’t inspire a lot of confidence
1 Like
I would suggest adding screws to reinforce this print. I have had multiple abec adapters fail on a weak DD at 30 motor amps.
Didn’t ride with them yet. But it’s onyx, I have no doubt of the fiability of it. I can’t talk for other kinf of plastics.
2 Likes
Adding screws with make the plastic weaker. I tryed a version with screws and I abandonned it.
1 Like
I used petg, so maybe onyx is strong enough. I also did not try printing in the orientation shown in the picture with supports. Doing that may be enough, but a little screw would definitely prevent the failures I had.
PETG and Onyx / markforged materials are not really comparable lol
4 Likes
Looking for a model of makerX Go-Foc SV6, friend asked me to print him a case but he’s still waiting on his order.
1 Like
Send me an sv6 and i’ll make you a model 
2 Likes
unfortunately I don’t have any
2 Likes
Anyone got a sketch from Trampa deck nose/tail with mounting hole pattern?
i do
gimme a bit
1 Like