I have 2 unties and a metr pro but they’re mine
teeze lmao…
What happened!?
Lol if you dont want it just send it too me
It’s fine Z
Got my avio remote. Synced it . calibrated amd tested all good… Re assembled the enclosure. About 2 hours later tried to power it on to tweak motor discharge . nothing. So I took it back apart. Jumped the switch and used my loop key. My receiver blinks but unity is a gonner.
Wth. That’s weird. I have had where my unity settings get wiped out but all I have to do is reconfigure everything again and off I go!
Damn. That blows
Dang it guys I just wanna buy a unity and metr lmao I kid I kid…
fuck that reminds me I gotta write down all my settings… they’re too perfect now
Lmao. It’s easy.
Motor amps 65
Battery max 55
Motor -45
Battery -8
Dead band input 6%
Positive ramp up time .10 sec
That’s all you need to know lol
Dash… psssst…
that’s easy for you… I have 3 boards with those orange boxes, all running wildly different set-ups… but I digress
Thanks Jc, I just sent @torqueboardsa message!
As kook brought up, does anyone know of any other esc’s/vesc that they would trust with running 13s? @CiscoV @kook @yelnats8j
Focboxes will be the way to go brother.
They are proven to work good with 13s. And supposedly unity does good too.
Do you happen to know if when I write settings through metr with two Vesc’s it writes to both? @rpasichnyk
You have to write one vesc at the time.
Vesc 1 and vesc 2
Whatever change you make to one you do the same to the other one
Alright, but only need to use one metr for the two of them right?
That’s correct. Learned all of this shit from my boy @Tello1969. Sickass builder and now racer