Why can’t people refer to the PWM output of most remote receivers as PWM instead of calling it PPM?
so much this.
I suspected it for so long, but once I looked at it on an oscilloscope and confirmed 100% that it’s a PWM waveform and not PPM, I changed what I always type to
7 Likes
Same. Even after I knew for certain it’s PWM, I was guilty of still saying PPM in convos for a while until I decided it really is important to be accurate with theses terms. I know bad habits are hard to break but we’ve gotta try.
5 Likes
Why can’t an over-hand (as opposed to in-hand) remote exist so I can wear my puck gloves?
1 Like
What is stopping you?
1 Like
- Puck and remote competing for space: puck winning.
- Wanting to slam my puck on the ground. Not wanting to destroy my remote.
1 Like
As far as nr 1. goes there is a solution.
I don’t slide my esk8 and use the slide gloves for fall protection so can’t help you with the other.
Hold on a sec. Do you try esk8steel?
1 Like
Why can’t bestech use simpler bloody names for their bms’s?
2 Likes
BMS’s is bad enough already. You are never sure when you are done saying S’s. See what I mean.
2 Likes
Bit like banana. I can start spelling but struggle to stop spelling it
6 Likes
Banananas
2 Likes
2 Likes
Oof. So glad i don’t need it.
1 Like
Don’t set him off or he will show you his other penis compensater.
1 Like
Why can’t someone design a decent one of those POS rubber thingies that go in your charge port when you aren’t charging? They are annoyingly hard to get in and most times when I charge I find it fell out anyway.
4 Likes
I’m considering this:
1 Like
I used the 3 pin of that, I like it I got the 3 just so it’s totally impossible to force it on backwards
4 Likes
That’s a good idea.