(Solved) Motor pulley gear stuck

[Excess]

Does the pulley have set screws?
If it does you could try the puller this way.

I cannot get this thing unjammed

Giant lack of big brain energy in here Just screw in two socket cap screws into the pulley, but not enough to tough the shaft, torch pulley, then use any sized 2 piece gear puller on the screws to pull it off… Gear pullers that can fit under the actual pulley are ideal… but the grab the screw method works great to get you to that point with larger thick pullers After you get the gear off, just pull off that belt retainer. Not needed if you even remotely align your pulleys… If you have a hard…