Nope, you are not the only one.
Am I the only one that thinks the ‘T’ looks like an IUD? 
12 Likes
Hope you’re good bruh.
1 Like
It’s not one? No wonder I’m cramping up now.
2 Likes
Nah. They copied Tesla
4 Likes
Thats fucked up they had a perfect opportunity to use a skateboard T tool, and they decided to rip off Tesla.
1 Like
Two of mine are doing exactly that.
Yep it was swiftly padded with alcohol when I got home and one band-aid had it covered.
I used to be an adventurer like you… Then there was this stupid metal pole sticking out of the grass at a 45° angle and it stabbed me right in the knee. It was pretty sharp but I wasn’t going too fast.
It’s like a conduit for some wires that go to a traffic control system, I angrily bent it into a upright position while people in the burger kind drive through watched my ordeal. Didn’t look like it was bleeding at first, only noticed when I felt the wet.
Washed pants before the blood dried and it’s like it never happened. Relief, I don’t have a lot of clothes.
Oh you meant hydrogen peroxide for the clothes?
1 Like
Yeah it removes blood from clothes 
That pole story is terrifying though… Makes you want to take unknown paths at like 5mph
I feel that pain though. Once I stabbed my leg with a horseshoe stick coming out of the ground, sort of the same thing 
What is this surface? It looks like how the ceiling was done in my parents house.
2 Likes
looks like a concrete finish…
BTW… sweet looking “TANK” board!
3 Likes
Make a 5 and a 2 1/2 then just stack them.
I came here to say that, looks like a tank. Awesome.
2 Likes
That thing is badass, it needs a big Bull Bar up front. ( good place for a spair tire lol )
1 Like
Did you add slime?
No. I am about to tho. I was on 20psi. But I just got that piece of wood out. It’s like a hook lol.
1 Like
No one makes a bull bar for these MBS trucks. Other wise I’d be so down. Maybe I will design one later down the road if nothing comes out
2 Likes
Working on it my man! Utilizes the brake holes and M8 hardware for extra beef.
Speaking of, @moon, do you have the profile of the matrix hangers? I’m very close to right and am tired of test printing blocks.
10 Likes
Kinda want a bull bar/carry handle but the back motors stick out too much to pull by the front and I don’t want to move them up.
1 Like