Thanks
Sure, here it is. It was a pain to model the outer face
Thanks
Sure, here it is. It was a pain to model the outer face
I can believe it. The one available previously than yours is missing so much details in comparison. Thanks a lot!
They are not impractical. They add grip. Since I havenāt installed any griptape yet, I consider that a useful feature.
As new again! Now Iām out of blue washers though. I hope I wonāt be forced to use red ones instead since the last thing I need on this board is more speed.
Oh dear god thank you. That one missing washer was killing me inside. Board looks dope now.
Put one red washer just to mess with people.
Oh, that would be fine. Like this:
Just not missing like a hobo tooth.
Thatās a really nice board
It is, and I would steal it if not for the being dead part.
Where did you find this other one? I modeled because I couldnāt find one
Do you have any idea price? Or more important, is it cheaper than Shredlights?
Yep keep going back and looking but still out of stock. tag me if a group buy starts interested
This is true, I have gone to buy them a few times and they where out of stock. I had to sourced an alternative. These where my first choice due to quality of the machining and tight fitment.
I complained about this issue back on the enertion forum.
Iāll have no part of a group buy / kickstarter / indigogo / risk-is-on-the-consumer. (enertion economics)
But there have been about 5 occasions when I tried to buy them and they were out of stock, including today. So, the sales are there, they just choose not to take advantage of them.
No tears will be had here when they are cloned by someone else.
I even posted this way back on September 9, two weeks ago, and they are still out of stock.
Maybe they want someone to clone them because itās too much work to make them? Iām sure China has a solution.
Or maybe, like Surf Rodz, they are too busy making gun parts (or something else) to care about esk8?
Either way, CLONE ON my friends.
Is this why I havenāt really heard from you the last few weeksā¦?
#sellout hahahaha. Wanna go skate this weekend thoughā¦?
Ah damn. Grabcad I believe. Itās the 80mm kegel, not the 85mm. Maybe you could use it as base for your model and save a bit of time
By the last pic, are you electrifying a table?
Just kidding