Should be. Its the carbon that is the issue. I would still prefer it to be on the deck side. Try it and see.
I will. If it works, it saves me the hassle of extending receiver wire.
Hobbyking do extenders
I have to fuck with it anyway, vx1 receiver plug is different than the makerx dual
Damn what did you do to the poor thing? And how did you get it replaced?
Are those @DerelictRobot’s FLEXL?
Can’t say looking at your hands but are you over the weight limit?
Rode emm on 100mm thane for about a month. No one associated with them has followed up about a refund or replacement.
The new hanger on the bottom is from @3DServisas
Let’s see how it holds up in comparison.
Lmao no these are my old rear trucks from my “Red Oni” build
I’m 180 but I do have thick fingers
Yikes that all it took? What’s the rate for a new hangar?
Yeah, apparently it’s an issue with 260 HeXL’s v1 or v2 (mine were v2’s) when you run thane.
I bought two sets when I picked emm up and the 260 “stock” tiller hangers are holding up fine on my 7” at board so far but I’ve only rode that set up a few weeks.
I hate to say it but I reckon the same thing witll happen on the 3ds hanger
Well I’ll be putting them through their paces for sure. These are going on my favorite deck.
Can you take a photo of these two showing the crossection?
Is the new one hexagonal too?
Thanks
Is it because they dont have the pivot tip with the angled parts that support the hanger in one piece?
It’s because they have holes where there shouldn’t be.
Counterbores
In the same place
Similar material
Similar hanger width
As the v1 hangers which snap
The hex pattern CF that Kaly uses is called WASP and you can find it on amazon. In case you couldn’t find it
Cool!!!
I havent really looked for it yet but now I dont need to. Thanks dude.