I cut a big hole in the carbon to give me some room to move with electronics. Do you reckon if the receiver sits against the new printed lid it will be alright?
5 Likes
Should be. Its the carbon that is the issue. I would still prefer it to be on the deck side. Try it and see.
3 Likes
I will. If it works, it saves me the hassle of extending receiver wire.
1 Like
Hobbyking do extenders
1 Like
I have to fuck with it anyway, vx1 receiver plug is different than the makerx dual
3 Likes
Damn what did you do to the poor thing? And how did you get it replaced?
3 Likes
Are those @DerelictRobot’s FLEXL?
Can’t say looking at your hands but are you over the weight limit?
2 Likes
9 Likes
Rode emm on 100mm thane for about a month. No one associated with them has followed up about a refund or replacement.
The new hanger on the bottom is from @3DServisas
Let’s see how it holds up in comparison.
3 Likes
Lmao no these are my old rear trucks from my “Red Oni” build
I’m 180 but I do have thick fingers 
1 Like
Yikes that all it took? What’s the rate for a new hangar?
1 Like
Yeah, apparently it’s an issue with 260 HeXL’s v1 or v2 (mine were v2’s) when you run thane.
I bought two sets when I picked emm up and the 260 “stock” tiller hangers are holding up fine on my 7” at board so far but I’ve only rode that set up a few weeks.
4 Likes
I hate to say it but I reckon the same thing witll happen on the 3ds hanger
1 Like
Well I’ll be putting them through their paces for sure. These are going on my favorite deck.
3 Likes
Can you take a photo of these two showing the crossection?
Is the new one hexagonal too?
Thanks
3 Likes
Is it because they dont have the pivot tip with the angled parts that support the hanger in one piece?
1 Like
It’s because they have holes where there shouldn’t be.
3 Likes
Counterbores
In the same place
Similar material
Similar hanger width
As the v1 hangers which snap
3 Likes
The hex pattern CF that Kaly uses is called WASP and you can find it on amazon. In case you couldn’t find it
3 Likes