What material/finish do you use with your kits instead?
Tasty stuff!
This was just spur of the moment. This is the highest jump I’ve ever made I was so scared lol. But we were just riding along the waterfront and decided to stop there. I saw a one wheeler so that jump and just had to try it.
But you’re right, must always wear a helmet!
Muito bem feito
Make that boy do chores untill he’s earned enough for a dickyho single drive. Make the battery like a 6S 10P. Capped low speed but still good range.
Ahah, obrigado! There are still a few details to polish but it went really well.
Did it do much to OD?
Could you put a wheel without a spacer next to it to compare please?
@Flasher these guys drive me nuts! How on earth is it even working, that’s fucking next level
Watch me!
@Vanarian the video says it’s from “the real life guys”
Didn’t see the original but this one had alot of the process in it. Seems pretty straight forward
@Tamatoa side by side:
@Brenternet yeah its reduced the OD a bit but i don’t think its enough to be a problem
Thank you, awaiting your first impressions after you ride them a bit.
Tire just looks better imo
Saw that a bit earlier on yt(german doods have done this). It’s a brushed motor with if I know it right 50W of powa.
God, if it can run this quick with 50W what should I expect when I run 2500W per skate lol
Definitely a dead rider on inlines.
Here the video.
Damn I’m fired up going to make some extra work right now (it’s midnight lol)
But these things have 25-100 NM of torque, because you know, gear drive.
Curious to know if anyone measured the actual torque we get out of our motors under boards btw, I’d say there is a constant with amperage and as you add reduction you multiply by that count?
And thanks for getting me to work lol I managed to shave down again 4 millimeters in height, makes a lot of difference for CG! Productive night.