Good to know, mine is a former (test) version.
Does the new version have the same slip-proof surface as the VX1?
Interesting, my Maytech V2 is for sure the first version.
Whaaat… the VX2 just dropped from the chair to the floor (carpet)
Unintented bench test failed 
Yeah, they feel almost identical.
Hope you like being twins because I have those fender washers, the oil slick matrix 2s, and a space themed deck coming my way 
is that the first Secret Santa package already?
Yes but indirectly… it didn’t really go over the “official” channel but as far as I can tell it’s @Goldrabe 's contribution… 
What case?
The battery box? Pelican 1200.
I’m trying hard to get decent amount of batteries underneath the deck with some 3D printed enclosure but it takes too damn long and I’m tempted to just do it the easiest way and get it going finally…
What are the specs for this battery pack?
It’s two 6s 10ah lipo connected in series.
Ohh I thought you use it for 18650 cells.
But people put 18650 in same case right?
Yeah plenty of space. 20700/21700 works too. We put a 12s7p 20700 cells with a charge only bms in a trampa monster box.
This is just for offroading fun rides. I don’t need a lot of range as of yet.
@M.Hboards yes this still bamboo. Is higheat quality bamboo from fujian. Made with vertical lamination.
Took me a while to figure out, connector cap wrong way around.
You may want to have a look at those PCB side solder joints, they’re not shiny.
Cool to have helped finance a nice purchase like that!
Excited to see your build.
@Arzamenable omg this is too funny
protip: use 10 coats of MG Chemicals #4223 and that little plastic piece is a thing of the past
and you can even solder through it if you need to later, unlike the plastic piece
Pliny elder 
Easy way to check is just reflow the solder.
What is this spring for?
Really though @torqueboards I think 50 emails is enough and I dont want to block you because I buy things but the unsubscribe doesn’t fucking work.
This is too much bud.
