Since you have access to noice tools, you could replace the axle for a stronger metal, maybe Titanium?
Yea I might just do that. If not I figure some snippity snappity things are going to happen.
Anyone knows if Caliber axles are a whole solid axle? Wonder how am I gonna remove it haha
You’re talking about CensorUnity?
More like it does a diyeboard truck on me and I face plant but yea, that too
I’ve got a guy:eyes: nice job btw
i got this exact same setup, gonna install it soon.
are you going to run idlers?
Was thinking about it, not sure if the torque is noticable enough to buy different belts again tho lol
“Technically” your mounts are upside down. But I’ve seen a few people do this now and you should do you.
You’re wrong, but you’re still cool.
Wrong.
Wrong.
Apparently I like to be different I’m so OCD it’s probably gonna drive me nuts now.
You’re OCD? Look again, I straightened the horizon
That’s looking good
Sadly not yet managed to figure out the sketch path for the rerouting to use the outer holes, need to do some sketch homework with the pipe combine. Guessing that’s what is needed
Those are the MR60 connectors? nice place to put em
Just if something hits the ground, it’s better to be a mount than a motor.
where did you get them made?
Laser cut, reasonable pricing for us
Should get 40 pc in a coiple of days
Thanks, I dont need anything cut but its good for people to know
I just got some custom x-things made for @Lee_Wright they were made in under 4 days start to finish. Anodized, sandblased and then laser engraved. Pretty impressive
If anyone has esk8 related stickers they dont want hit me up
@moon how do we get those dope stickers??