You’ve got a big stick
5 Likes
Nobody beats Andrew on the Xbox…nobody
2 Likes
Wow! how did you fit all the 8 wires between the 2 truckbolts? I tried the same but for me the sensor wires couldn’t fit between that gap (needed to have something to guid them outside the riser)
IDK lotta dead things on the road. Just today a car pulled out and I had to swerve into the path of some rat guts. 
2 Likes
I had no problems with it.
Use the ver.1, it has a less sharp bend.
2 Likes
That looks clean as fuck
2 Likes
Thanks, i plan to have a silicone gasket seal behind it that is snug round the cables and keeps everything watertight. Wondering how much it would cost to get some made in aluminium or stainless steel.
2 Likes
@longhairedboy could you add 2x like buttons? So we can like it twice if its so good as this one eheheheh
1 Like
I’m reposting it because I feel I should gets at least 50 likes for the hour it took my unskilled ass to make
6 Likes
Since you have access to noice tools, you could replace the axle for a stronger metal, maybe Titanium?
1 Like
Yea I might just do that. If not I figure some snippity snappity things are going to happen.
4 Likes
Anyone knows if Caliber axles are a whole solid axle? Wonder how am I gonna remove it haha
You’re talking about CensorUnity? 
3 Likes
More like it does a diyeboard truck on me and I face plant but yea, that too 
1 Like
I’ve got a guy:eyes:
nice job btw
1 Like
i got this exact same setup, gonna install it soon.
are you going to run idlers?
1 Like
Was thinking about it, not sure if the torque is noticable enough to buy different belts again tho lol
“Technically” your mounts are upside down. But I’ve seen a few people do this now and you should do you.
You’re wrong, but you’re still cool.
Wrong.
Wrong.
5 Likes