He built that in the enclosure for absolute sure.
1 Like
It even rhymes 
1 Like
i found the old cell in it… 
1 Like
Haha should make it easier than my 3 bits of wood and an old power bank technique I used previously
1 Like
i will check this. it might be an issue actually.
I now remember the smart bms was temporily showingfluctuating currents
I like the color mix of the copper heatsinks and the green 3d printed pla case… good job 
1 Like
It is made from ABS. I don’t think the heatsinks would heat up to 60C, but who knows 
1 Like
he said it was physco but idrc
That was a comment based on the fact the phase wiring is swapped from left to right. When you build the internals in the enclosure upside down on the deck you usually run the corresponding wiring to the opposite motor so that when you turn the enclosure over to fix it the phase wiring is left to left and right to right. Been there done that 
Makes absolutely no difference bar aesthetics
2 Likes
nice to know
1 Like
Damn, it’s gonna be a looker- thats for sure
6 Likes
Fender washers is the magic search term
5 Likes
You can also use sex bolts. They aren’t the same at all but I wanted to say sex bolts.
Still viable though 
3 Likes
UMMMMMM TB Vesc 6? TB FOCBOX? hmmmmm
2 Likes
Almost … gotta make a last minute change on the PCB design but so close… Will need some testers soon to BREAK it @ShutterShock
15 Likes
Oooooh I wanna get on that email list lol
2 Likes
I like to break shit.
And have a tendency to crash, push stuff too far, and swim with my shit.
3 Likes
Yooooo. Dexter. How you doing?
2 Likes
200lb guy here with nothing but a skateboard to get around.
2 Likes