Maybe you didn’t have spacers installed.
Ouch dood, you are not on the lucky side with wheels i suppose.
Rafaelalwayshacksawingthemwheels!
Skate and destroy, Bro!
@rafaelinmissouri well the good news is: you know your dye job went through and wasn’t just on the surface
Are you able to charge at the full 5A? Oh and how did you connect them together? I need to find a connector to cut up…
I’m only using a 18v 3A supply now and that limits me to about 1.7A @25.2V
I read that modern PC power supplies can put out 18A on the 12v rail so it should definitely be enough.
They are still in the factory
What cells are these?
For a minute I was wondering how you lathed out that world record wheel chunk. The truck makes a bit more sense
I don’t see any chunk… yet…
These wheels have yet to see any mileage.
He is referring to this:
It is just my luck dude… I ride strictly on perfect pavement…
How’s that deck working out for you? IIRC you’d mentioned something about the kicktail basically convex flexing the board when you use it? I’ve been having a hard time deciding on it or a @b264 deck because of that.
So far it has not been that big of an issue for me. if your enclosure stretches all the way from baseplate to baseplate then the convex might be an issue since it’ll bend while the enclosure wants to stay rigid.
The convex apparently makes the ride less bumpy because of the ‘mild flex feeling’
It only charges at around 3.6-3.8A from what I can tell, but that’s fine as my alternative for now was nothing since I lost my original brick. To connect them I plug them all into a strix / JB v2 balance board, and then plug that into my charger.
What happened to recieve two sets of trucks
Man they must be feeling generous. They sent me extra baseplates along with my original order and someone else got doubles.
Yeah, they did a pretty piss poor job on the engraving on one set of my trucks, so I got repeats of those, and I ordered a single hanger support and two other single hangers, they all came as pairs.