You guys are some mighty detectives though.
Ain’t nothing getting past you guys. Haha
You guys are some mighty detectives though.
Ain’t nothing getting past you guys. Haha
There must be some kind of police department in Australia someone could report this to, right?
Edit
Let’s page an Aussie here @glyphiks
Someone get Chifley Advisory on the line
Did they find out if you were a robot yet?
Next job for you Internet sleuths…
Find a picture of the owner of torqueboards
#unmaskdexter
I did two years ago, but I won’t post it.
It exists somewhere is all I’m sayin’
haha… lol
Is this the blackmail that gets you first dibs on those big wheels?
I make a habit of not talking to police
Negative, that’s the redmail
Can’t blame you that usually isn’t their specialty.
But wasn’t there a guy who was suing Jason personally? Not the company?
Can’t remember what came of that, pretty sure Jason just hid under a rock
hope ya got it fixed… but if not… check the filament tube at the top of the extruder… do a cold pul of the filament… then take out the capton tube… freshly cut it flush… you may have to clear a filimant bockage at the junction on the tube and the extruder…
creality filament tube holders are cxrap… i bet you have a blockage right at the junction of the extruder…
Consumer Affairs is who you wish to be contacting. I’m not sure how far you’ll get but if you’re able to provide all evidence (photos and videos of all fraud and stuff) you should be able to get somewhere. I don’t have the patience to report him honestly
annnnnnddddd it’s gone.
Yeah probably, that rings a bell.
@kalebludlow I thought that there might be someone who is motivated enough to take it somewhere🤷♂️
It is just so ridiculous.
If you wanted to do it properly you would want to compile years of bullshit from JP. I’m sure there is someone obsessive here who would love to fuck him more than anything
I’m sure there are also folks here who would like to get him put in jail or fined.