Reply to "Pictures and nothing else" thread

Media
#13336

This rings true to me. I know that Jeff and Ben are addressing the motor temp fluctuations in fw5.0. Until then, im turning off thermal throttling

#13337

That being said, does anyone know how to turn off thermal throttling? Im not seeing an option in the mobile VESC tool

#13338

@BenjaminF could always just cut the temp wire for a permanent fix

1 Like
#13339

Running with scissors again?

5 Likes
#13340

Mine have survived two and still kicking, no wrist plate on the back though.

2 Likes
#13341

what is thaaaat. A between 2 CAN devices connected metr?

So my guess is that both can devices get connected to the metrCan and metr sends commands/infos to each device. That way both UART Slots are free?

5 Likes
#13342

You guess

2 Likes
#13343

when can i buy that

9 Likes
#13344

Tell me we can plug in a GPS module or it has a GPS built in

3 Likes
#13345

Basically a datalogger? Can the bottom part interface with existing metr pro modules?

1 Like
#13346

Me and my coworker were dumb and got wiped out by a wave. The lava rock tore my feet up pretty good

10 Likes
#13347

@kook

1 Like
#13348

ya “rick-rolled me”

#13349

that’s sweet!!!

5 Likes
#13350

Thanks, that axle though :stuck_out_tongue:

3 Likes
#13351

we donn need no stiiinkin’ axles…

2 Likes
#13352

There will be a port on the board. :blush:

8 Likes
#13353

Yeeaaah, demonseed ? v2 44"?? Lucky you ! :stuck_out_tongue:

2 Likes
#13355

What bearings are those? Anything special? Match the wheel core color perfectly

#13356

Boa bearings, silicone nitride

3 Likes