Ooooh, Cedric was riding these in Paris and had mounts for them. They look solid.
They are solid - made for Downhill. So we maybe need to work on the Baseplate concept to get them more steerable.
Yeah, thatâs what I understood that they werenât so nimble.
Very interested!
Use a simple and cheap 3 part oil, or a gun oil; put a drop when ever you canâŚSpend money in cheap new bearings if they are goneâŚUsed then and treat them like shitâŚdo not waste your time or money on bearingsâŚjust my advice
đźď¸ Pictures and nothing else!
The board and the large spoonâŚreminds me of The Matrix. Siiiick setup.
Christ thatâs a lot of focboxâs, whatâs going on with the yellow one?
Beautiful board! Hope youâre making a build thread for it, or at least share some more pictures!
What motors are those?
theyâre the zillboards motors. constant power of 3500w and peak 6000w.
theyâre yet to be released
Do they have sensors? (hopefully not)
What Kv are they?
Is the rotor keyed to the shaft with a 3mm key?
What are the resistance and inductance from the VESC motor detection?
Are the magnets affixed with epoxy thatâs flush to the magnet surface? (âbattle hardenedâ)
Do you have a photo of the inside?
Are the bearings ceramic?
I hope they do, because people who donât need them can just cut the wires off which is way much more easy than adding a hall pcb and wires for the people who want sensors
This is true, but it also uses up space where you could have a bigger stator instead
With the advancements in software recently, sensors are doing less and less imho
Sensors still>HFI
With all my experiences with sensors, unsensored BLDC, and sensorless HFI, I will still pick sensorless HFI as the best in my opinion for street skateboarding. If I had bindings and/or rode in the woods, it might change my mind though
Yeah but the HFI thing still need a bit of development time to work flawlessly and easy on every motor.
Still hope it will be a thing for mtb applications too, but for now it doesnât look like unfortunately
Yes, I notice this too. But so far I am very impressed with even the first versions. I do have some motors that work way better than other motors, though. Even same motor and same ESC, sometimes it just works better than other times.
I think we already on a good way and I hope the developers still keep up working together like they are doing it right now. Things just need time.
Meanwhile, we can start getting the new motor designs not using up valuable winding space on sensor assemblies