steel gears?
Yes ofc!
oh rip, you alright after that? Trying to work out what happened, did you hit something nasty that dragged the wire down or was it a sleeve problem?
Iām guessing the nut wasnāt torqued down enough and a hard brake caused it to slip. Ask me how I guessed
Yup, this happened. Havenāt examined it up close but should be good still, just needs a fixer-upper
Ahemā¦ lights? You?
Next youll be wearing shoes
Want this one to be a commuter as well, so gotta be prepared!
I truly hope this board is a tank for you and treats you right. Youāre due for a set it and forget it build.
Thats the plan! So far Frankendick has been exactly that, so iām hoping this one can be the pneumatic equivalent for sure
per the loaded unlimited manual, u r supposed to torque the axle nut to 25Nm, no more or less, and check the torque each week
Yeah, errrr I totally did that
same, i totally check the torque each week, definitely have been doing that since i put it in storage half year ago
That means itās a terrible design then
feel free to email them and tell them how bad of a job they did:
They donāt care about a product theyāve discontinued.
I want griptape with this pattern on it
NGL, totally thought you were showering your board
Yeah its only a 630kg shuttle lift. Probably is the same size as a double shower
How to take your mountain board indoors if you are a no-shoes-inside household.
Iāve just bought one! Donāt suppose you know where I could get a user guide?