Added it to an ali order just for this… was under $10 from memory
2 Likes
Damn! When i was looking at them at the tool shop they were like 60 bucks or something.
I just spray paint dicks on them until they get fixed. Tomatoes potatoes.
2 Likes
steel gears?
1 Like
Yes ofc!
oh rip, you alright after that? Trying to work out what happened, did you hit something nasty that dragged the wire down or was it a sleeve problem?
4 Likes
I’m guessing the nut wasn’t torqued down enough and a hard brake caused it to slip. Ask me how I guessed 
3 Likes
Yup, this happened. Haven’t examined it up close but should be good still, just needs a fixer-upper
3 Likes
Ahem… lights? You?
Next youll be wearing shoes
2 Likes
Want this one to be a commuter as well, so gotta be prepared!
2 Likes
I truly hope this board is a tank for you and treats you right. You’re due for a set it and forget it build.
6 Likes
Thats the plan! So far Frankendick has been exactly that, so i’m hoping this one can be the pneumatic equivalent for sure
3 Likes
per the loaded unlimited manual, u r supposed to torque the axle nut to 25Nm, no more or less, and check the torque each week 
3 Likes
Yeah, errrr I totally did that 
4 Likes
same, i totally check the torque each week, definitely have been doing that since i put it in storage half year ago
3 Likes
That means it’s a terrible design then
feel free to email them and tell them how bad of a job they did:
1 Like
They don’t care about a product they’ve discontinued.
1 Like
I want griptape with this pattern on it
1 Like
NGL, totally thought you were showering your board
3 Likes