So nice 
1 Like
Thanks, but there’s no issue. The bolts are intended to be that long maintain good contact with the hub adapter without going all the way through to dig into the gear case.
Despite the visible gap, the axel spacers keep everything locked in place so I can use the full width of the hanger.
1 Like
Keep in mind that the hub adapter holes aren’t threaded. The bolts can just slide in and out.
There might be no issue now but bolts can bend… Increasing the bolt length increases the chance of bending them, as the torque increases.
I don’t know how thick those screws are but be careful!
2 Likes
That’s exactly where I’m going.
Force distribution is crap with long bolts.
2 Likes
it’s the rampant authoritarianism in modern social society.
some people just get off on exercising ultimate control over how people express ideas.
don’t even
6 Likes
That’s a huge exaggeration if not out right misrepresentation of what happened and why. The “why” is a setting that auto locks threads if enough flags have been set by community members over a period of time.
2 Likes
The amount of times I don’t notice… 
2 Likes
Ahh so it’s a mob mentality
Or maybe people are sick of your bullshit, my dudes.
Again, if you think everyone but yourself is the issue, it’s probably you that’s the issue.
9 Likes
Same set up as me, they are M4 bolts I know they have to be longer mine which are 45mm
1 Like
This is shaping up to be a mental build. Have you decided on trucks yet?
8 Likes
Castor wheels for that freebord vibe 
3 Likes
Words to live by right here.
7 Likes
I can’t afford to do batches of colour, at least not at the moment
@jack.luis
Woah fat belly
Bow ba dow.
You chubby chaser, you.
I knew how to properly reply to PANE posts for a glorious 15 seconds yesterday.
1 Like
Nullblox pressed. I just added the layer of glass and shaped /cut it.
5 Likes
Nice looking board!
The red/green looks great but is opposite to the standard for determining direction (oncoming/receding)…on purpose?
2 Likes
