thats a meaty set up, for you or your boy?
Gonna see if it’ll lug me around or not
I’m sure that will get you going, looks cool so far!
Nice, what is that drive train off of?
The axle is from an old shriner car, the motor and diff is meant for a go kart supposedly.
T-nuts are terrible for esk8 in my experience. May you have better luck.
If those are top side & grip tape will be going over them it’ll probably be fine tho.
Nope, bottom side. I hope they hold up! If not, I’ll try from the other side as you’ve suggested.
Putting a tiny pan head wood screw like this may be a good retention mechanism. Will stop giving unsolicited advice now tho
Thats not a bad idea. But it’s bathed in epoxy. Under and over. It wont move.
I did this on a deck recently, but yours look a lot better.
Yes there is. I have adapters for them.
Yeah it’s an eboosted evolve gt enclosure - fiberglass absolutely destroys wood blades
He should put a photo of that blade on his site
what battery enclosure is this?
For future cut and shut jobs. Use one like this.