Will take a look at it 
- You’d need a perfectly aligned motor mount and wheel hub to avoid it
- The motor pulley is often wider than the belt, so it has space to shift back and forth
- Life happens
4 Likes
Indeed belts rarely run true. The pulley is a bit wider than 20mm to accomodate for this, but a lip would still be better. Will see how it goes with these prototypes 
2 Likes
Just about 300 miles haha. And yes, many burnouts were involved. I cant help it if this thing carves like a dream 
1 Like
Lost my loooong spacer and had to steal some bits from an escooter axle.
Don’t make the lip too small or the belt can hop up onto it, and once/if it does, it’s very difficult to get off because the belt wants to stay on the crown.
Why? Appearance? Wheelbite?
1 Like
Very nice!! Is it the Mini S? Have to share some drag race data with each other!
1 Like
Yeah, just arrived.
Don’t really have a race board but keen to time some T race and try some drags 
No idea on setup, if you have used one maybe I’ll hit you up for some tips.
Cheers dude
2 Likes
Yeah I’m still very new to mine. I’ve only used it with RaceChrono so far as I’d used RaceChrono in the past so that was fairly easy for me. I’ll definitely share any insight once I’ve played around with mine a bit more and used the RaceBox app.
1 Like
Cool. Yeah I downloaded RaceChrono so will have a go with that first up and try figure it out. Will report back!
1 Like
Why what? Why use a long spacer or why did I lose it?
For the former, I lost it because I was dumb and crashed with shitty axle nuts
1 Like
used this same light exactly four minutes before the mount broke
1 Like
I think he means why are you separating the wheel from the truck so far.
It could be because of wheel bite but it’s probably for aesthetics reasons.
If he has such a long axle intended to use with a pulley, getting spacers in the outside part of the axle it’s pretty ugly lol, it would look like two spikes coming from the side of the skateboard lmao.
1 Like
There’s a pizza place near me that has plastic bags with four cutouts, so when you put the box in the bag it stays flat.
It is so convenient when carrying them with the skate, but if you go fast you might have aerodynamics problems🤣
3 Likes
This is a huge problem when carrying pizza.
I put it in a pizza bag, but another bag could work, as long as you have a good grip on it with straps. I usually carry it from the bottom, but any way to keep the wind from catching and flipping it over is fine.
1 Like
No, why put the spacer on the inside? You’ll have a slightly better vehicle if you put the spacers on the outside of the wheel, as long as you aren’t getting wheelbite.
My next goal in esk8 its going fast enough that i can carry the pizza perpendicular to the floor 
