Yep - slow boat shipment lol itās gonna be a bit.
Your setup is looking real good tho, I havenāt had the tail lights on my board since I switched to newbee drives (mounting them to those is another task on the long list)
Iām calling them āC8 Tail Lightsā they will be available when the shipment comes. Not sharing my website around yet as Iām still finalizing some things but weāre getting close. Iāll be making an official Vendor Corner post when Iām ready.
While Iām still working on ways to mount to Jump Drives, the Newbee 4gs, etc, they do come with an elastic strap that can be used on certain setups. Iām also thinking about options for mounting to my esc enclosure, or on top of a rear truck baseplate
I think it has a protection circuit board under the top and/or bottom contacts, extending the length of the cell. Most lights use protected cells these days.
I did. The wheel can take both 22mm and 28mm bearings. I am going to test this version for a while then I will have a good idea when the wheel can be released. I am aiming for a retail price of around $350.
But I suppose thatāll fit the curvature of the rim right? I guess those running gear drives will have more of the thread of the screw exposed? Or would it not be compatible (canāt tell exactly how this thing screws together)? Say like BN AT drives for instance.
i got a brightside looking for a home if youāre keen. its like the baby brother to the darkside, slightly less extreme in the concave/features department. very similar to the omakase.
Considering using protected cells in a board?