Itās what came with the drives. Heated them up to loosen because of the red loctite but didnāt reheat to tighten again (wasnāt sure if I should because the other side tightened down ok without heat)
2 Likes
Oh, which drives are those?
1 Like
Newbee 4GS. I swapped my wheels to new wheels and had to adjust the drives out a few millimeters, so I had to loosen the clamp screw. Other side was fine, this oneā¦ not so much
2 Likes
Maybe new bolt or retemper
Yeah makes sense, it seems like it would also help to seal up the bolt holes with silicone or something though. I was watching a video about a caravan build where he was very careful to silicone any screws going into the wood so there wouldnāt be water entering through that little gap in the weather sealing
my first thought was. Midjourney AI generated photo for āelectric skateboardersā
1 Like
Yeah, Iāll have to figure out the best route to get this one out.
1 Like
Is it possible to fit a nut with some Loctite 638 on the bottom exposed threads? Then you could thread it out the other end, right?
Yeah, Iāll have to figure out the best route to get this one out.
2 Likes
If you can see the other side maybe hit it with heat & the right size one of these, first use one side to make the guide divot then flip & use the extractor in reverse
DMAXO 05 Pcs Damaged Screw Extractor Set - Broken Screw Removal Tool - Screw Remover Drill Bit Set for Damaged Screw Heads - Stripped Screw Extractor - High Speed Steel 4341 62-63 HRC https://amzn.eu/d/bSCQ2KM
1 Like
Thatās a pretty respectable pace my dude 
3 Likes
First ride in ages, been too lazy so gonna try to get the LDP board out more often for a bit of fitness 
3 Likes
Hell yeah, love to hear that! What are you skating?
also ill have to get some app to record my analog laps
Ride app is free 
My LDP board is a bit of a diy hack.
Loaded dervish, chopped and skinned with cf and setup on gbomb brackets. Bennet w/. Spherical on front randal rear, speed vents.
2 Likes
Personally, iād just be buying a new clamp 
1 Like
poor manās herringbone
1 Like
Reversed polarity on the charger/charge port?
2 Likes
Whereās the dude that was here riding CBSā boner asking for proof of them being unsafe?
1 Like
Precisely why I asked first haha. Could be user error I suppose buuuuut Iām not thinking so.
Nope! Was using it as usual, with a standard onewheel XR Charger. Went on a ride the night before, and charged it overnight as usual, and in the morning it smelt like burnt electronics in the garage. Contacted Chi and they blamed it on a pinched wire in the battery box, even though it was installed exactly how their own install guide said to install it. (Also there was not a pinched wire that I could see) Quite disappointing from Chi, especially as the battery was only about a month old, and they only offered $100 towards a new one.