@Tanuki you certainly got that million screw aesthetic lol. It’s not a big deal, but (visually) it kinda bugs me how the screws aren’t uniformly spaced with relation to the spokes tho
3 Likes
Lord knows you don’t need that many either 
Are the outer rings for aesthetics only? It looks like just there’s a lip on the inside so it has to be printed
2 Likes
Bugged me too, but this is the best solution as I have to spare out the part where the tube valve comes through. 
Hahaha yeah they are mostly there for the looks. They hold the front lip/flange though, which gets printed separately, so they are not completely useless.
Heat set inserts or through bolted?
Inserts for the cap screws, through bolts for the outer ring.
1 Like
Beadlock?
what about just using 10 screws?
I hate every single one of your answers here, ANDREW.
2 Likes
Most Andrew’s are full if shit anyways…
MOST
2 Likes
Every single rat bastard one of them.
3 Likes
Looks a bit empty then.
soldered crimp lugs… 
Is there a reason not to do that besides the whole “Crimps are better because in theory a perfectly done crimp is better than solder” thing?
1 Like
Yes, it hurts my soul. Besides that, you’re right on the money.
1 Like
Oi, i just did what the instructions said
Curse the duck then!
Hereby sentence you to death
1 Like
Whats wrong with my xt30 
1 Like
Whats wrong, looks good to me?
1 Like
Insulation not butted against bullet face.
Idk. I hate excess bare wire
4 Likes