3D Printing Discussions, Questions and Debugging

[Arzamenable]

The battery builders club

[image] I was really proud of my original balance leads. Ran them out of sight all the same length didn’t cross up and good solder points. My first pack I cut the ones with extra to reach the further ones I believe I actually had to glue a couple bc I could not get a good solder point. I just have to mount my charge port and figure out how to mount these rockstars to the bn gear drive and I’ll finally be rolling yerpp [IMG_0556] [IMG_0555]

@Holdmebeer did you figure out mounting for the bn drives?