Hello everyone
By any chance, can someone make me some bullet connector extenders? My motor wires are not that long and I want to route them though riser pads. Would that be possible? We can work out the details after. If so, please PM me. Thank you!
What size bullet connectors and what AWG? Does that also include hall sensor cable?
Here’s the link
Not the sensor wires. They are plenty long
I have some 4mm to 5.5mm bullet connector extensions. Is that what you need?
Looks like you need 4mm female bullet > 12awg silicon > 4mm male bullet. How long do you need the extension?
Oops sorry I didn’t respond. I don’t have any 4mm female 
Those are good but a little too long
I’m trying to figure that out. The bullets from motors are in the worst spot. Basically on the bend of the wires in the riser.
Shoot. You’ll probably have to back them out a bit, unless you’re willing to solder an extension directly to the phase leads (i.e. don’t use bullet connectors to extend)
Hm, not that confident for that. I mean I could rotate the motors and use the extensions. At that point it’s just luck if it’ll work or not.