No UART Controller Options in VESC tool?

On two VESCs I have, one is FSESC 4.2 on FW version 3.103 using Ackmaniac tool, another is a Maytech VESC 4 on FW version 3.40 using VESC tool 0.95. I’ve been using a Flipsky VX2 remote. The remote works and I can set the motor parameters just fine, but I have no controller options under UART:


The UART option looks like this on both of my VESCs. What’s going on? What should I do if I want to adjust my throttle/braking curve?

4 posts were merged into an existing topic: Noob question thread! 2020_Summer

2 Likes

Thanks, apologies for the spam
@xsynatic could I get this thread deleted?