I have a unity and two 3d printers
π NEED a Storm Core Owner and a Unity/Xenith Owner (Preferably people that also have 3d printers)
1 Like
I was toying with a tapped bottom plate. It actually makes it way easier to install. Sadly there are some inherent flaws in the design
1 Like
Thanks, but I think we are good for now, @Venom121212 and @falcon87407 have been super helpful.
2 Likes
I fixed the part, I made all walls a minimum of 1mm thick. I am going to print it now and make sure it is fine structurally. Then you guys can print a final one and do one last test fit.
3 Likes
Sounds good man. Thanks
2 Likes
Donβt thank me, thank you. This would have been a much bigger pain if we didnβt have such a cool community willing to help.
3 Likes