I’ve been neglecting this build, i have been busy getting life shit together. But the shit is togetherish now so it’s time.
Sanded back the overfill on the top of the deck, went reasonably well, perhaps even a little better than expected. Proceeded to sand the rest.
Now typically I would just make an enclosure at this point before doing any more work to the deck, but after following and drooling over @MatteoFPV 's build thread, I’ve decided to shamelessly plagiarise his build.
So the plan is as follows:
- Take a female mold of the surface of the deck
- Cut a big fuckin hole through the deck
- Construct a structural ‘tray’ beneath the deck
- Use the female mold from step 1 to make a lid.
I created a flange around the deck so that my female mold will also have a respectable flange. Bed time now, will glass tomorrow night 