I be using a 100.00 dollar bill…anything else would be uncivilized
For these gear drives, you can get away with using a $20
Why not put the motor on the inside of the hanger?
So you can go to the rear with 6355 with alittle truck mod to gain motor clearance. Definatley not with 6374 tho
How long is that hanger?
You did good
I’m also using a 44° baseplate. 50 might be alittle better(for clearance) but I like 44 on the back and 50 on the front
Now that’s Ultraboard shit right there
My ultra first board. Lol
Pretty tight clearances with sk3 6374 and a top-mounted drop deck. They sound better than expected. And the instant torque is insane.
Trying to do math to figure out what pulley combo i can use on the vx2 that matches the gear drive ratio so my speedo works.
1:2.78 is like 50:139, haha. 5:14 is probably close enough.
You gonna be wang-dang-bangin’ those motors all over the shop with that clearance lol.
Only reason I’m letting it ride this low is because I mainly ride just the neighborhood and the roads are butter with zero potholes. I may pick up larger wheels to bring the ride hight up but it works for now.
5 motor, 14 wheel in the pulley settings?
Yep.
Dope, thanks! I’ll give it a test tonight.